MK3/4 Axis Speed Issue

[Designosaur]

I am rebuilding my CNC router controls with a MK3/4 and DQ542MA drivers. I have 2 ball screws on my main axis connected to axis 2 with 4 slaved. When I tested this setup, everything works fine.

The X axis is connected to Axis 1 with the same settings. When I run it, the DRO looks correct but the movement is only a very small fraction of what it should be.

The settings on all 3 drivers are the same, they are wired the same, and the axis steps/rev are the same.

Can anyone point me in the right direction to troubleshoot this issue? Thanks!

Similar Threads:

• Spindle speed issue PRT-E750. Spontaneously speed floating.
• Please Help! Issue that cannot be resolved. Stalling Z Axis Issue
• Newbie- Seems Z and A axis are not running...Motor issue or Step/Dir issue?
• Issue with Mach 3 Speed when running 4 Axis
• Need Help!- Mach 3 Speed Issue on four axis foam cutting setup!!

[PlanetCNC]

Check Steps/Unit setting
https://planet-cnc.com/set-steps-per...-tng-software/

Here is list of other beginner tutorials:
https://planet-cnc.com/howto-setup-c...-tng-software/