- Single input limit switchs?
-
Registered
Single input limit switchs?
Hi
I have Mk3/4 card on my milling machine. I have tried found right way to setup limit switches.
I have connect axle x to limit 1 and y to limit 2. I have check "single input" on settings.
Result is X-axle switches will change to colour on -x-axle and Y-axle switches +x direction. Like two input case?
What all settings will take part this?
Jari
Similar Threads:
-
-
Member
Re: Single input limit switchs?
How did you connect limits? Could you post image or diagram?
Are you sure that your X limit switches are connected to Limit 1 and Y limit switches to Limit 2 terminal?
- Single input limit switchs?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules