I am trying to do a VCarve of some Japanese symbols. During the clearing operation with a 1/8" bit, I am receiving an error from the Controller software (Compass). GCode and image of the error is attached. Code error is on line 2525 of file.
Thanks in advance - Shawn
Similar Threads:
- Problem- What type of error : Delta Internal Error![Movement Error]
- Problem- What type of error : Delta Internal Error![Movement Error]
- Need Help!- 18i Error 3000 PMC-MACRO Contact ERROR random error on Tool Change
- Need Help!- Has anyone ran into this error? Parasolid ® Kernel Interface Error: KI Error Code:58
- UPgrading From VCarve 3.1 to VCarve 4 or 4.5
That is the software that Camaster is bundling with their new Yaskawa servos. Not sure if another controller is going to work easily with them. Not thrilled with it for sure. I have already had one bug I found....
It is hard to get to the drives to take a picture as they are all covered up with sheet metal, but I will see what I can do. When I had looked at them before (had to swap one out), there was nothing visually interesting to me, but who knows.
In the mean time, support for Camaster found that if they slowed the feed rate in half, the error went away. So, that got me going again....
Yes, the feed rates look high on the first operation but not too high for the second operation, what is the max feed rate for your machine that should give you a number you can work within
Max Rapid Feed rate is different to the Max Cut Feed Rate
Mactec54
Max cut speed is 1500 ipm, and I often do full cuts of 3/4" ply with 3/8" compression bits at 650 ipm. Since it is the second tool that caused the issue (at 150 ipm), I am not sure what the real issue is, but hopefully Compass will be able to help figure it out.