Newbie Vcarve pro general setup question


Results 1 to 2 of 2

Thread: Vcarve pro general setup question

  1. #1
    Member flminnow's Avatar
    Join Date
    Oct 2021
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Vcarve pro general setup question

    Hello everyone. I'm beginning my CNC adventure. To get started, I purchased a Stepcraft M.1000. I ordered Vectric Vcarve Pro with the machine. I have attached a photo to help you understand my question better. Vcarve is asking for a configuration. The options it offers, in a drop down box, for my machine are:
    UCCNC toolchanger
    UCCNC
    WinPC-NC toolchanger
    WinPC-NC - toolchanger

    I purchased the following spindle and it DOES NOT have a toolchanger:
    MM-1000DI 1000W Spindle (Standard)


    My question is, which of the above selections is the correct one for setup in Vcarve?
    Thank you

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Vcarve pro general setup question-configuration-question-jpg  


  2. #2
    Member
    Join Date
    Dec 2003
    Location
    East Anglia,England
    Posts
    1048
    Downloads
    0
    Uploads
    0

    Default Re: Vcarve pro general setup question

    I think you have answered your own question;you don't have a toolchanger and only one of the options is for a machine without a toolchanger.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Vcarve pro general setup question

Vcarve pro general setup question

Vcarve pro general setup question