error message 101 101

Results 1 to 4 of 4

Thread: error message 101 101

  1. #1
    hunt3r's Avatar
    Join Date
    Feb 2012
    Location
    Dahlem
    Posts
    155
    Downloads
    0
    Uploads
    0

    Default

    Hello
    According to my error manual the error is called “”interface not under voltage”. However I don’t have a clue what that means. I would appreciate if anybody could help me out.

    PS: I have a Maho MH 400E and on the monitor the message 101 2times after each other is displayed.



  2. #2
    CNCMarci's Avatar
    Join Date
    Jan 2012
    Location
    L?denscheid
    Posts
    245
    Downloads
    0
    Uploads
    0

    Default

    Good morning

    Have you got a Phillips CNC432 controller on your machine?

    If yes, then that error message comes up directly after the main switch is switched to ON. (as far as I remember). Then you have to unlock the controller. Afterwards the error should be gone!


    If not, then I don’t have a clue

    Kind regards



  3. #3
    Administrator CNCFanatiker's Avatar
    Join Date
    Dec 2001
    Location
    EE-Kreis / Germany
    Posts
    5129
    Downloads
    0
    Uploads
    0

    Default

    Hello hunt3r

    Write a bit more detailed when the message comes up- when starting the machine? (that would be normal)

    To avoid misunderstanding, do you really mean 101 or I01? (with I for interface).

    Or is a different letter before the number?

    Gruß / Regards
    CNCFanatiker
    AdminCrew

    Wenn wir immer das tun was wir können, dann bleiben wir immer das was wir sind.
    If we always this act what we are able to do, then we always remain what we are.


  4. #4
    hunt3r's Avatar
    Join Date
    Feb 2012
    Location
    Dahlem
    Posts
    155
    Downloads
    0
    Uploads
    0

    Default

    Yes, it says I01 I01. Then I unlocked it as you said but then the error message #05 I01 comes up. There is no hash key in front of the 05 but a similar sign but I also don’t know what that message means. When I start the machine then I come to the machine constants and I cannot go into another menu. Could it have anything to do with the 3 switches at the back on the door of the switch cabinet.????



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

error message 101 101

error message 101 101

error message 101 101