power supply change

Results 1 to 4 of 4

Thread: power supply change

  1. #1
    Metalltechnik's Avatar
    Join Date
    Mar 2012
    Location
    Matrei
    Posts
    15
    Downloads
    0
    Uploads
    0

    Default

    I have a Maho MH 1000C ( Philips 432). The power supply of the CNC controller is probably damaged
    Can anybody tell me how I could check it and what I need to consider when replacing the power supply with a new one?



  2. #2
    Registered mtronik-kit's Avatar
    Join Date
    Mar 2005
    Location
    Reichau
    Posts
    1513
    Downloads
    0
    Uploads
    0

    Default

    Hello

    I guess that your power supply is on the right side of your controller.
    With these power supplies you don’t have the possibility to check the voltage.
    Unless you take the controller completely apart. Then you can measure the voltage on the backplane.

    Regards
    mtronik



  3. #3
    Metalltechnik's Avatar
    Join Date
    Mar 2012
    Location
    Matrei
    Posts
    15
    Downloads
    0
    Uploads
    0

    Default

    Do I have to consider anything when taken the controller apart?
    I already read out the parameter...



  4. #4
    Metalltechnik's Avatar
    Join Date
    Mar 2012
    Location
    Matrei
    Posts
    15
    Downloads
    0
    Uploads
    0

    Default

    Hello

    You only have to mark the plugs
    Regards



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

power supply change

power supply change