- MH700C
-
Registered
Hello everybody
I have bought the MH700C. So far the machine was running without problems.
However since yesterday the machine just stops in the middle of the program and the following error is displayed: ERR 01, 05.
01 = interface cut off
05= emergency stop of the machine
On the warning device, the number 54 gets displayed ( unfortunately I don’t have an error list for it)
I have already filled up oil in the hydraulic system and the lubrication system.
Would be great if somebody could help me out...
Kind regards
TomE
-
-
Registered
Hello
Unfortunately I don’t have the required circuit plan either but on the 300C i get the error message 1Q1, motor protection main motor fan.. you could have a look at that..
Regards
Mtronik
-
Registered
Thank you I will check that tomorrow thumbs-up.gif
Fan of the main motor, would that be the spindle motor???
Regards
Tom
- MH700C
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules