Hello Mikko
sorry for the late answer.
I’ve got them only in German :-(
Best regards
Mahoist
[attachment=6204:MC_9_432.pdf]
Hello
Does anybody have a machine parameter list for the machine Maho MH900C with cnc432 controller?
At the moment I need the complete parameter list and I'd like to buy a service/parameter manual for this controller.
Regards,
Mikko
Hello Mikko
sorry for the late answer.
I’ve got them only in German :-(
Best regards
Mahoist
[attachment=6204:MC_9_432.pdf]
Gruß / Regards
CNCFanatiker
AdminCrew
Wenn wir immer das tun was wir können, dann bleiben wir immer das was wir sind.
If we always this act what we are able to do, then we always remain what we are.
someone has the machine parameters for machining center MAHOMAT cnc 432?
thanks.
Hi;
I have a boehringer vdf 250 c with a cnc 32bt controller . During diagnostics one of my IO cards is detected and five no fault , but it gives all I and O are on 0 even if they are on 1 .
I switched cards , the same probleme with another card at same position.
Hi. Is it possible to set a soft start and a spindle stop somewhere in the parameters? (Continuous). I have a MAHO 600 with Philips 432. It has an Indramat A31 frequency converter. When it runs at about 1000 rpm. , and turn off the spindle, it stops immediately when it hits. Thanks for help.