- kavo 4444 remote control
-
Registered
kavo 4444 remote control
I have a kavo spindle and driver (4444) mounted on my Tormach mill, and would like to use the remote control features of the driver accessed via a 25 pole subd connection. Unfortunately the manual contains only the most basic description of the connection. It aludes to much greater detail and function but doesn't supply the detail, the damn teasers!
Thus far the US dealer has not been forth coming, likely because this is a discontinued model etc.
Do any of you have this info?, If so I would appreciate any assistance.
Thanx
Wayne
Similar Threads:
-
-
Member
-
Member
Re: kavo 4444 remote control
I have one of these as well and would like to control it with an arduino.
-
Member
Re: kavo 4444 remote control
I have been looking for this solution for years. I have gotten it to work recently. The trouble is the drawings are not correct. You want to use pin 1 as the common for shorting out pin 3 for start and pin 15 as the stop. These are only needed momentarily and act exactly like the front panel buttons.
- kavo 4444 remote control
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules