Hello,
I am pretty new to all this CNC stuff. I have been working on trying to figure out if the old Chinese spindle is still good. It is a 220v 10amp 2.2K water cooled spindle. I bought a Hitatchi NE-S1 inverter and have been trying to program it.

I have tried to run the spindle a few times. If I have A001 (freq. source) set to 2 and F001 set to 400, the spindle will run but idles at around 50-55(im assuming hz?). If i set f001 to less than 400, say 300 I get Error code 30.

These are my current settings:
A001 2
A002 2
A004 400
A003 400
A082 220
B012 10
H003 2.2
H004 2
F001 400
A061 400
A062 120

Any help would be great!

Similar Threads: