Is this because the controls don't have a full keyboard? If so, you can write the macros on your PC then transfer the program via RS-232 or Ethernet.
Hi,
I just wrote a macro Program on Fanuc Oi mate - TD control. The program works fine on Fanuc Oi Mate control.
I also want to implement the same on my older machines which have Fanuc O T control.
I am not able to type the following things on old control -
1. #3000 = 1 (To generate alarm)
2. #501 = #2801 (To copy geometry offset in common variable)
3. If [#510 GT #509] GOTO 999 (This is the tool offset check condition)
Please require assistance on how to write these codes on older machine or can it be accomplished by some other codes?
Thanks
Ashish
Similar Threads:
Is this because the controls don't have a full keyboard? If so, you can write the macros on your PC then transfer the program via RS-232 or Ethernet.
You sure you have macro on the old control? Was an option back then.
Sent from my A3-A20FHD using Tapatalk
Hey it that really possible? If I transfer that codes via RS232C port then can I really run the program on older machine.
How to check whether the machine supports Macro A or Macro B on my old machine?
one of these examples will create a alarm
Macro A format
b)Addition #i = #j + #k
G65 H02 P#i Q#j R#k;
[Example] G65 H02 P#101 Q#102 R15 ; (#101=#102+15)
Macro B format
#100=#101+15
But how to type # or = character on the control
As all can see in the attachment, I type the buttons below DELETE button, then is it not getting typed.
That # character is only typed when I type certain alphabetical character such as A, B