- Need Help!- Tombstone milling macro needed
-
Registered
Tombstone milling macro needed
I am in need of a face milling macro to true up the tombstone in my HMC. It is a fairly old Kitamura Hx 400 and the B axis had went bad. And to correct it the tombstone had been milled to compensate. We just got done fixing the issue with the B axis so now the tombstone look like the top was just twisted and pulled up.
Ideally i would want start at lower corner move over in X, retract Z, go back to Original X, increment up in Y, back in Z at depth and so on. Only macros i have been able to find start at center and incrementally go out from center.
Similar Threads:
-
-
Registered
Re: Tombstone milling macro needed
I found out that my Kitty has built in milling cycles they just needed to be turned on. They just run completely in background like G83 Canned cycles and the like.
- Need Help!- Tombstone milling macro needed
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules