computing power for OPUS

Results 1 to 2 of 2

Thread: computing power for OPUS

  1. #1
    Registered SaschaSlow's Avatar
    Join Date
    Apr 2012
    Location
    Hamburg
    Posts
    8
    Downloads
    0
    Uploads
    0

    Default

    Hello guys

    I am a newbie here in the forum!

    I tried to find out today what computing power is necessary for the OPUS. However I was not able to find out much from the supply side.

    It’s about a complete 3D programming, simulation of the whole machine with all of the interfering contours.

    I believe that the computing power that we get here in the house it not sufficient so it would be great if you could tell me what system configuration you use.

    Regards
    Sascha



  2. #2
    CNCMarci's Avatar
    Join Date
    Jan 2012
    Location
    L?denscheid
    Posts
    245
    Downloads
    0
    Uploads
    0

    Default

    Hi
    We have a ThinkStation D20 in the best configuration from Leonovo for our PEPS(3D & 2D milling, wire-cut EDM).

    I think that's a bit much though....



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

computing power for OPUS

computing power for OPUS