- open source Atmel/arduino PID motor control
-
05-01-2018, 01:54 PM
#241
Member
Re: open source Atmel/arduino PID motor control
That certainly is not right. Your zero cross detector is suppose to sync with your line freq. Are you triggering your 'scope to the line freq? Else it will stay the same if it triggers with itself.
-
-
05-01-2018, 03:03 PM
#242
Registered
Re: open source Atmel/arduino PID motor control
No, my scope doesn't support such high voltage.
The signal shown previously is the Arduino's input.
-
05-01-2018, 03:42 PM
#243
Member
Re: open source Atmel/arduino PID motor control
I would use the Arduino input (ZC) to also trigger your 'scope and then 'scope your pulse output of the Arduino, which should move position with pot rotation.
-
05-01-2018, 04:24 PM
#244
Registered
Re: open source Atmel/arduino PID motor control
I am afraid I don't know how to do that.
-
05-01-2018, 05:10 PM
#245
Member
Re: open source Atmel/arduino PID motor control
Have you used EXT trigger?
Must be a front panel jack for an external trigger. You would this jack to connect to the ZC signal going to your Arduino input. Then set your trigger mode to external. You monitor on channel 1 (or 2) the Arduino output pulse.
I don't have your type of 'scope so I can't give specific steps to follow.
-
05-01-2018, 05:31 PM
#246
Registered
-
05-01-2018, 06:16 PM
#247
Member
Re: open source Atmel/arduino PID motor control
So the pulses do move relative to the zero crossing signal. The next step is to figure out why the motor doesn't change rpm with the pot change.
-
08-09-2019, 12:19 AM
#248
Re: open source Atmel/arduino PID motor control
Hi all,
this project have a protection about motor stuck or over current or not?
Thanks.
-
08-09-2019, 10:09 AM
#249
Member
Re: open source Atmel/arduino PID motor control
The protection is a fuse in the motor wiring. The fuse should be sized such that if the motor stalled the fuse will blow. This fuse amperage selection will vary depending on the motor selected and its current ratings.
- open source Atmel/arduino PID motor control
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules