Working the holes in your molds


Results 1 to 1 of 1

Thread: Working the holes in your molds

  1. #1
    Registered HuFlungDung's Avatar
    Join Date
    Mar 2003
    Location
    Canada
    Posts
    4826
    Downloads
    0
    Uploads
    0

    Default Working the holes in your molds

    This is a general question about making quicker work of doing holes, lets say dowel pin holes in a mold, using a slot drill for drilling the hole and milling a counterbore, or simply enlarging the hole.

    Just about all other canned autoroutines on my Shadow controller I could live without, but I really like the spiral type circle clean function, called a G27. This controller also has other things that it will do, such as rectangular pockets and facing routines, but I've dropped the usage of those long ago, because it is easier to do in CADcam than to make up the pocket out of one's head.

    Anyways, the spiral circle clean G27 function just goes beautifully hand in hand with any of the drill cycles. Peck your way down and then counterbore the hole at a selected depth. I am not knocking Onecnc. I think provision for this type of process is extremely rare in CADCAM software.

    Does anyone else use autoroutines like this? Note, this is not a cycle, and cannot easily be set up as a cycle, because it needs to be called every time it is desired: it is not modal.

    Now I haven't learned to use Onecnc's hole making routines all that much and maybe I could dispense with this yearning, if someone wants to clue me in. It just seems that it is cumbersome to drill and counterbore a hole "the solid machining way" because it is difficult to combine a peck drilling motion, followed immediately by a counterbore procedure.

    As a matter of fact, it is quite easy to "subtract" a hole from a solid, counterbore and all. But it seems difficult after that to gain control of just the operations required to do the counterbored hole.

    So what do you do?

    Similar Threads:
    Last edited by HuFlungDung; 04-10-2003 at 11:23 PM.
    First you get good, then you get fast. Then grouchiness sets in.

    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Working the holes in your molds

Working the holes in your molds

Working the holes in your molds