Peter,
you are surely not fooling around when you're working! LOL! I used to share my premises with a Patternmaker, it's a very interesting trade.....
Klox
Hello Peter,
Yes. 6000 mm/min. If it were 6000 m/min I was going to ask where I had to get a plane ticket to, to watch that cut.
In a past life I made rock maple supports that had the contour of helicopter main rotor blades milled in them for transpotation purposes. All programmed with the best tools I had at the time. A programable calculator, a graph pad, a teletype and alot of cussing .
Things sure have improved.
Dan
Peter,
you are surely not fooling around when you're working! LOL! I used to share my premises with a Patternmaker, it's a very interesting trade.....
Klox
*** KloX ***
I'm lazy, I'm only "sparking" when the EDM is running....
thanks dan for seeing my error if it was going that fast i would bought everybody a plane ticket
klox
your quite right it is very intresting plus
they are master patternmakers
thankyou for comments
best regards
peter