Hi Scott
Here is the post for your c-tek controller
just unzip and put in your settings folder where OneCNC is installed on your pc
C-TEK.zip
I am looking for a post for the above controller. C Tek also know as a CNT Controller The machine goes under the brand name guise of 'powercentre' in the UK, all be it an optimistic name I have no idea if this machine/ controller is marketed in the USA or other countries. I guess it must be as they have to be sold somewhere.
I have already posted in the onecnc forum but that's a little used forum with not a lot of exposure it seems.
I have attached an image of the control if case it rings any bells with someone seeing this controller used with onecnc
Any information or even a post to try would be appreciated.
Kind regards,
Similar Threads:
Last edited by scott0031; 05-25-2014 at 07:25 PM.
Hi Scott
Here is the post for your c-tek controller
just unzip and put in your settings folder where OneCNC is installed on your pc
C-TEK.zip
Last edited by hasanmmm; 02-18-2017 at 02:06 PM. Reason: fault
Hi ,
Can anyone help out with the post processor for the same CTek machine as above but running bobcat V21 ??
Thanks
Hey guys thanks for the file for One CNC and Ctek.
Ours has the same control as pictured.
I've tried to load a program from onecnc into the machine via floppy disk and having no luck at all.
There's not much out these about these machines. Any help greatly appreciated
Matt
BUENAS NOCHES, AL MOMENTO DE INTALALR EN MASTER CAM NO ME DEJA ACCEDER
Hi Matt,
My employments workshop has this type machine, and have been battling as well. Ours doesn’t have a floppy but I’ve seen the Rs-232 cable work to a usb and laptop. I’ve been programming manually in the meantime. I’ll keep you posted with progress… does anyone know what file type C-Tek/ CNT accepts?
Hi richyrich
Im programming with solidworks solid cam and i need to save the file as .cnc for it to accept it
I am also battling to get the right post processor to communicate properly with the machine as some of my programs dont want to work on machine but it does on the simulation
Hello. Does anyone have information about controlling the milling machine with c-tek control.
Thanks you.
duotrigordle