Just a quick update. Nothing much to report. Cutting well.
Some resonance on the servo I tried to tune once in a while.
Still totally satisfied. It's not 100% but I'd say 95%, and it might only be 95% for any router.
Its nice my old router is nearby, I get to see how much slower it was.
Syntec controller remains quirky but fine (sometimes loses the network and takes a few tries to find it again).
Most recent small issue was a loose sensor on the tool change piston, which stopped everything in mid change. Took a little bit to narrow that down and sort it out.
Sent from my LG-D852 using Tapatalk