OK, still only 6 zones hooked up but working on the spoil board today.
Working on getting some help from omni to reprogram the syntec. The factory settings are overly minimal in spots. I should be able to turn the relay on for my vacuum and dust collection with an m code but none are set up past what the tool changer needed. Even the usual ones aren't set up, like coolant mist/flood even though they hooked up the vacuum to the air/mist button.
Also the dust hood is not yet controllable by gcode though it was in the contract. Hoping we can get all these sorted out with an updated configuration file of some kind. Basically ideally I want m code to trigger the vacuum, dust collection, dust hood, and trigger a few empty relays for possible future use (air clamps or such).
Anyhow a few pictures.
I hope to get a good amount of test cutting done tonight on my regular materials.
Oh and I tried a tramming indicator on it. A little off but we'll see with the milled spoil board.
Sent from my LG-D852 using Tapatalk