Need Help! Help with Okuma OSP5020L controller with display screen issues


Results 1 to 5 of 5

Thread: Help with Okuma OSP5020L controller with display screen issues

  1. #1
    Member Tezz4818's Avatar
    Join Date
    Apr 2022
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Help with Okuma OSP5020L controller with display screen issues

    Having problem with monitor in our okuma OSP5020L controller . It start off with screen turning yellow after being on for a few hours and could reset by shutting down and startung back up untill a point screen was yellow all the time . After a bit of bacwards and forwards with diffrent comanys we got a new led screen from monitech in the US fitted perfect in controller but when we pluged in screen come on but no display. Has anyone had the same problem?
    Thinking of looking in to a whole new controller, okuma want $12,000.00 plus. So thinking about converting to a diffrent controller all together. Has any one done this and if so what type did you change too

    Similar Threads:


  2. #2
    Member OkumaWiz's Avatar
    Join Date
    Apr 2009
    Location
    United States
    Posts
    1262
    Downloads
    0
    Uploads
    0

    Default Re: Help with Okuma OSP5020L controller with display screen issues

    I'd say just to work with monitech to get it working. They should support what they sell. I think it's just settings on the display since it's pretty common to replace the CRT with an LED.

    If they can't do it, then contact Invision @ 262-521-2000. They can probably help you out.

    Experience is what you get just after you needed it.


  3. #3
    Member
    Join Date
    Jan 2009
    Location
    USA
    Posts
    55
    Downloads
    0
    Uploads
    0

    Default Re: Help with Okuma OSP5020L controller with display screen issues

    I installed a display from Monitech to replace the display on my 5020,,,,the instructions at that time left something to be desired. That was around 4 years ago, maybe the instructions still need updating? I did get mine working and it's been fine.



  4. #4
    Member OkumaWiz's Avatar
    Join Date
    Apr 2009
    Location
    United States
    Posts
    1262
    Downloads
    0
    Uploads
    0

    Default Re: Help with Okuma OSP5020L controller with display screen issues

    Tezz,

    According to Monitech, they have a two year warranty and they will require a special adapter cable to adapt to the Okuma signals. Are you using that? They offer support for their products...call them.

    Their instructional videos below:

    https://monitech.com/products/okuma-...d-upgrade-kit/



    Experience is what you get just after you needed it.


  5. #5
    Member
    Join Date
    Jan 2009
    Location
    USA
    Posts
    55
    Downloads
    0
    Uploads
    0

    Default Re: Help with Okuma OSP5020L controller with display screen issues

    Looks like this.

    Help with Okuma OSP5020L controller with display screen issues-20220412_094924-jpg



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Help with Okuma OSP5020L controller with display screen issues

Help with Okuma OSP5020L controller with display screen issues