please, question about transfer cut


Results 1 to 4 of 4

Thread: please, question about transfer cut

  1. #1
    Member deadlykitten's Avatar
    Join Date
    Jun 2015
    Location
    Antarctica
    Posts
    4131
    Downloads
    0
    Uploads
    0

    Default please, question about transfer cut

    hello after cut-off between spindles in G140, i change to G141 in order to machine on 2nd spindle

    during this sequence, 2nd spindle stops ( after transfer as slave for 1st spindle that stops ) then starts spining again under G141 mode

    please is it possible to stop only the 1st spindle, and keep revos on 2nd ? thus is it possible to use M150 without stoping s2, or is there a wayarround ? kindly

    Similar Threads:
    we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...


  2. #2
    Member Algirdas's Avatar
    Join Date
    Mar 2009
    Location
    United Arab Emirates
    Posts
    1982
    Downloads
    2
    Uploads
    0

    Default Re: please, question about transfer cut

    you need turn off the spindle sinchronisation instantly after transfer.



  3. #3
    Member OkumaWiz's Avatar
    Join Date
    Apr 2009
    Location
    United States
    Posts
    1262
    Downloads
    0
    Uploads
    0

    Default Re: please, question about transfer cut

    The Spindle will return to what it was doing before M151 was activated so if revolving before it will be revolving after. M151 can be activated either stopped or spinning.

    Does direction change when going into G141 vs cutoff?

    Experience is what you get just after you needed it.


  4. #4
    Member deadlykitten's Avatar
    Join Date
    Jun 2015
    Location
    Antarctica
    Posts
    4131
    Downloads
    0
    Uploads
    0

    Default Re: please, question about transfer cut

    thank you mr wizard i thought that s2 has to be static before m151, i also thougt to trick it by making the transfer in g141 ?!

    but you are right, it can be also spining, and after m150 it will reverse to whatever was doing before; nice trick how did you find it ?

    it was the chery on top for my list related to dual spindles :
    ... static transfer, normal or with orientation
    ... cut of transfer, with protection for blade and detection if part is still in subspindle
    ... turning and milling a long part, being clamped in both chucks
    ... using 2nd spindle as tailstock
    ... keep s2 spining after transfer for continous machining, by avoiding useless stop

    please, is there something else ?

    Does direction change when going into G141 vs cutoff?
    yes, normally it does, or so far it was like that now, for some repetitive simple parts, thanks to you, is possible to use L hand tools / kindly

    we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

please, question about transfer cut

please, question about transfer cut