hy what options do you have at " workweight (main spindle ) " ? i understood that now it is at " no chuck ", but what else is there ? okuma dealer is the one that can enable them; is ok if okuma dealer recomanded setting change, but is not ok if options are not enabled; they should enable that even if machine was delivered without a chuck
to be sure that you check only main spindle, use M150+G140; if it works in M150, then begin to investigate also 151Now this problem isn't just during the transfer when they are synced together. But it is only on the main spindle
you mean 3" spindle bore ?Which is our LB3000IIEX with 3" spindles.
i have acceleration times for 3000series, normal and big bore; i will share them and test program as reference
besides workweight, there is at least other spindle acc parameter; i will look for it a bit later / kindly