Need Help! Okuma MX-55 With U10M Control System


Results 1 to 2 of 2

Thread: Okuma MX-55 With U10M Control System

  1. #1
    Member Jangsher's Avatar
    Join Date
    Oct 2021
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Okuma MX-55 With U10M Control System

    Hii Everyone

    here i have okuma made VMC MX-55 with U!0M control system.
    i have a problem with Rotary table axis called A axis,when we run rotary axis in cycle mode, it rotate 360 degrees. But some times 1 or 2 times out of 10 it rotates and return to 358 degrees and stop without any alarm and there is no stop in auto cycle, cycle run continously.

    so please help me to figure out problem i will be very thankfull to u all.

    Similar Threads:


  2. #2
    Member OkumaWiz's Avatar
    Join Date
    Apr 2009
    Location
    United States
    Posts
    1262
    Downloads
    0
    Uploads
    0

    Default Re: Okuma MX-55 With U10M Control System

    I would check the encoder to make sure that it is tight on the shaft. 2nd check the Actual position display to see if when it is at 358 degrees that the actual position values of RCON(command), RAPA(actual feedback), and RDIF(difference of actual and commanded) show 360, 360, and 0. If they show 360, 358 and 2, they you most likely have binding in your A axis.

    Best regards,

    Experience is what you get just after you needed it.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Okuma MX-55 With U10M Control System

Okuma MX-55 With U10M Control System