Need Help! Okuma Pallet Changer Crash


Results 1 to 3 of 3

Thread: Okuma Pallet Changer Crash

  1. #1
    Member j209177's Avatar
    Join Date
    Aug 2021
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Okuma Pallet Changer Crash

    I recently got a Okuma MX-45VAE with a OSP700M control from an auction. I got one of the board fixed, added new oil, then moved the axes. Then I tried the pallet changer out in manual mode. I got the machine to move over in X, the door to open, and the pallet to unclamp. Then it wouldn't do anything else. I found the page that says the sequence number and the parameter page that has the APC sequence number. The sequence was step 6. I didn't realize this later but pallet "B" was loaded on the machine and pallet "A".

    I have tried many thing to get it to move so I am a little fuzzy on what I did. But here we go I changed the sequence number to 7 and pallet A moved to the load position even though pallet B was already in the machine.
    Then I changed sequence number to 6 (if I remember right) and it started to pull pallet B out of the machine even though pallet A was in the way.

    How do put pallet A ( the one on the pallet changer ) in the storage position ( front of the machine)?
    How do I put pallet B back in the fully loaded position in the machine?

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Okuma Pallet Changer Crash-20210909_140732-jpg   Okuma Pallet Changer Crash-20210909_140741-jpg   Okuma Pallet Changer Crash-20210909_140748-jpg  


  2. #2
    Member
    Join Date
    Oct 2009
    Location
    world
    Posts
    92
    Downloads
    0
    Uploads
    0

    Default Re: Okuma Pallet Changer Crash

    Hellog

    I think there is a missing diagnostic message. The missing diagnostic message is splash guard open signal that is not in screen.. You have to be careful when doing with parameter. You have to know the sequences.



  3. #3
    Member j209177's Avatar
    Join Date
    Aug 2021
    Posts
    2
    Downloads
    0
    Uploads
    0

    Default Re: Okuma Pallet Changer Crash

    Thanks for replying. I put in the sequence number in and pushed APC reverses and it sent it to the right place.
    Also it turns out the riggers attached some of the wires in the control box backwards.
    Now it works correctly.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Okuma Pallet Changer Crash

Okuma Pallet Changer Crash

Okuma Pallet Changer Crash