both of course
All,
The parts book list the drive belt as a 12PK1445 Rib Ace. What is on the machine is a 7PK1445 and a 5PK1445.
Should I go with the two belts, as the factory had it, or the wider single belt? (which would avoid the chance of slightly differing lengths on the two belt system)
I've owned the machine since it rolled off the Okuma line...so it came with 2 belts.
Similar Threads:
both of course
Any information as to changing the spindle encoder timing belt? LNC-8
Check if it is needed. Normally the encoder belt is not heavy loaded. Evaluate wearing and decide.changing the spindle encoder timing belt?