There is the parameter for speed limit also.
How do you check:?There is no g50 speedlimit command
Hi guys,
i have an okuma LB15 with osp5000 control.
If i set a spindle speed it will run only at half rpm. The maximum it reaches is 1400 rpm. I checked the 2 gears and they work fine, the tachometer is already new and shows the right rpm. The machine has no erros or fault codes, everything seems to work fine except the spindle speed. There is no g50 speedlimit command, i checked that too.
I don´t know what to do next. I called some technicians, but nobody has a clue.
Maybe you guys have an idea for me what the problem could be.
Thank you
greetings
giovanni
Similar Threads:
- Ideas about the half plasma half router table seen on TESTED?
- Need Help!- Spindle turning at half speed?
- Gweike laser cuts at bottom half of bed but not top half
- G Weike 1290 Suddenly cutting at half speed in curves only: HELP! PLEASE!
- G Weike 1290 Suddenly cutting at half speed in curves only: HELP! PLEASE!
There is the parameter for speed limit also.
How do you check:?There is no g50 speedlimit command
you seem to have checked all of them . Did Your machine reloaded system software?
Sent from my iPhone using Tapatalk
What about spindle speed override?
Check if the spindle speed is possible to change using the spindle speed override knob.
Try setting your max spindle speed with the G50 Zxxxx where xxxx is your maximum spindle speed.
You stated that there was no G50 specified, but you may have a situation where a previous setting is still in place and by re-entering the new limit, it may reset the maximum RPM.
Don't forget to also set your high gear range, usually M42 for that machine.
Worth a try.
Cheers
Brian.