OSP7000M control Floppy conversion to USB help

[Fireater]

I have a 1999 Okuma MX 45VAE w/OSP7000M control with a Floppy drive and I would like a conversion to USB if possible, any directions or suggestions??? Any help is appreciated.

Similar Threads:

• Okuma floppy to usb conversion
• Build Thread- Okuma MX 45VAE Floppy conversion to USB
• Floppy Drive to USB Conversion Kit
• Floppy to USB Conversion Kit
• 3.5" floppy to USB conversion?

[Algirdas]

Check once again if your OSP is equipped with USB. Shouldn't be.

[Fireater]

Check once again if your OSP is equipped with USB. Shouldn't be.

No looking to convert to USB I have a floppy.. Looking for the right set up that proven and how to do it.

[Algirdas]

did you try:
jumpers on MO; S1; JA and JB ?

[Fireater]

I have a Floppy Disc drive in my control panel I want to replace it with a USB emulator in its place. I need a emulator Model No#?? and wire/pin configuration ?? that will work. Wire Diagrams, directions any suggestions??

[Lsg]

SFR1M44-U100K USB can be used instead of the original floppy drive?
l-shuguang@sina.com, I mainly do OKUMA maintenance services

[Lsg]

SFR1M44-U100K?M0?JA?JB?JC?

[kurmay]

Information about this has been given before. If you search the forum you can find this information.

if control unit is OSP7000 , you must use 4 jumpers on MO,S1,JA and JB
if unit is U100, 2 jumpers on MO and JA