OKUMA OSP U100L PARAMETER 3position KEY SWITCH

[okuma1984]

would you guys buy these switches from mcmaster carr? ? i need a EDIT LOCK EDIT UNLOCK LOCK switch any idea?

Similar Threads:

• Problem- Okuma LB300///OSP U100L
• Need Help!- M-tool will not start, Okuma LB300 OSP-U100L
• Problem- Okuma OSP U100L serial on a LB300
• Need Help!- Okuma Lathe LU15/OSP-U100L
• Subprograms, Okuma Lathe LT10 Osp-U100L ?

[okuma1984]

does anyone have a parts book? or a part number? they should all be the same no ?

[kurmay]

Hi

Hope this helps you.

https://www.onlinecomponents.com/en/...c22b-11334519/

https://www.mouser.com.tr/datasheet/...04-1512172.pdf

[okuma1984]

kUrmay to rescue again. you are full of useful information. thanks, buddy

[lshingleton]

If you cant find a switch just leave unlocked and protect the programs instead ---better way for sure

[okuma1984]

If you cant find a switch just leave unlocked and protect the programs instead ---better way for sure

i think it was in 12 o'clock position when there was no key. but i need to get into parameters somehow.
like i don't need that to change way lube timing eh? are you familiar with the control ? and parameters?

[lshingleton]

Yes at one time i worked on them from the control was new i think in 1996 to about 2010 ----------Good controls and we had hundreds of MX40 and MX50/60 Machines and some of the Crown and LS lathes

[kurmay]

Here is explanation of edit interlock