Probably faulty memory unit.
Hi Guys,
This machine is old and fights me every few months (it seems)! LB15 with 5000L-G control.
I had not used the machine in a few weeks, it was fine when last I did. Anyway this morning on boot up I got this SBP Monitor message along with all the LEDs lit on the panel. It wont go any further. Tried to restart a few times, got the same result.
Any ideas?
Similar Threads:
Probably faulty memory unit.
https://www.facebook.com/okuma.tuning
BTW can I use a panel from a my other lathe for testing? Its a 5000L looks very similar to the 5000 LG in fact the same buttons and layout, can I use these boards and panel section for testing on the LB15 ?
UPDATE:
This issue was resolved by replacing a faulty circuit board, Okuma LC-30 Opus 5000 II CRP B Board 1911-164-1-1371 J52 XPS-442A
From an LC-30 lathe but compatible with the LB15, slid it in and she fired right up!