LB15 "2561 RS232C ready interrupt time out error"

[rotec]

On my LB15 (1990) all of a sudden when I try to send data to the lathe I get this error "2561 RS232C ready interrupt time out error".

From lathe to PC no issues. Never see this before.

Same cable same programs. Any ideas?

Similar Threads:

• Como cambiar la condición "NOT READY" a "LSK" en un controlador Fanuc GN6 T-B
• Acramatic 2100 control Error 39-6 and pendant z axis drive "not ready"
• Need Help!- Error 152 "Drive not Ready"
• OSP 5020L on LC-30 "2561 Error" Help
• 2561 Time Out Error

[kurmay]

Maybe there is a wrong parameter set

[rotec]

Maybe there is a wrong parameter set

Yes I suspect you maybe correct, I just tried a second PC and it does the same ie CNC to PC ok but PC to CNC after data transmits I get the time out error.

For the LB15 lathe with a 5000 L-G control do you know the parameters?

[OkumaWiz]

Your error message means that it is not receiving the “go” signal in the allotted time. Check Parameters like Kurmay says to see if XON/XOFF or software handshaking is selected. Not very likely the machine settings changed but much more possible on the PC. Check there first then be sure to READ on the machine before sending from the PC.

Best regards,

[kurmay]

Check this

https://www.cnczone.com/forums/okuma...ngs-okuma.html

http://www.suitefactory.com/download...%20osp5000.pdf

https://www.aggsoft.com/cnc-dnc/okum...a-osp-5000.htm

[machinehop5]

...good time to backup the Parameters what ever they are set at currently...if you can still send to PC. other possible things to check I've seen failed/weak memory batterys cause problems. Bad grounding, RF noise near the cable.

[Raj199]

I am facing the same issue now. But when I checked the parameters it looks like it has gone back to the original values. I changed parameters back to what is recommended in the online forums to no result. Has there been a fix for this issue?

[Algirdas]

a fix for this issue?

Did You try to find out the reason of the fault?