Okuma 5020m Randomly switched to Metric


Results 1 to 2 of 2

Thread: Okuma 5020m Randomly switched to Metric

  1. #1
    Member Solid_Brass's Avatar
    Join Date
    Mar 2013
    Location
    USA
    Posts
    20
    Downloads
    0
    Uploads
    0

    Default Okuma 5020m Randomly switched to Metric

    Came into to work this morning with my Cadet 4020 (OSP 5020M) displaying units in Metric. Checked my parameters and found the "Data Set Unit", under the : "Input Unit System" page in parameters had switched to metric (pic attached). Switched it back to inch and re-started the machine. It went back to metric. I can switch it to Inch run parts just fine, but every time it is shut down it reverts to metric. I don't recall changing any settings or parameters last friday, so no idea whats going on. I am not an Okuma expert, learning this machine/controller as I go. Any ideas?

    Thanks,
    Dan



    Similar Threads:


  2. #2
    Member OkumaWiz's Avatar
    Join Date
    Apr 2009
    Location
    United States
    Posts
    1087
    Downloads
    0
    Uploads
    0

    Default Re: Okuma 5020m Randomly switched to Metric

    Check your program, it is possible to have the program switch units if parameters are set right and the code is used in the program. You might want to set it to inch and then single block to see when it switches to discover easier.

    Experience is what you get just after you needed it.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Okuma 5020m Randomly switched to Metric

Okuma 5020m Randomly switched to Metric

Okuma 5020m Randomly switched to Metric