Just looked at to buy a Okuma LB10 single turret OSP5000. On start up it shows 108 alarm A EC power off 1. Can a turret that might have been put back together wrong or miss aligned be a cause of this alarm? I read that this is emergency stop circuit related.
Seller said after he worked on the turret, this is when the alarm happened. It has set unused for several years since. He didn't say that it had been crashed, but that the turret had some loose bolts. I cycled the emergency stop button and the on/reset button repeatedly in case of dirty switch contacts. Seller said there was no jumper on the amphenol bar feeder connection . He said that he had never run it with a a bar feeder or chip conveyor.
Can a open sliding door/key switch position trigger this alarm on start up? I have had no experience with Okumas.
Thanks

Similar Threads: