OKUMA OSP U100M 1313 ALARM A EROR

[Samed42]

hello
I have a horizontal machining center MA 50 2001 model machine. everywhere of the machine works but when i start the magazine manually, OKUMA OSP U100M 1313 ALARM A EROR i get this error when i can do it
?mage—>

Similar Threads:

• Okuma OSP-U100M Programming manual
• OKUMA OSP U100M HELP FOR SMALL MEMORY
• OSP-U100M Alarm
• Okuma OSP U100M / U10M
• help ex 1313 alarm

[Sergeyrusa]

Hi

1313 Safety monitor error detection
The safety speed monitor detected over-speed or abnormal state and stopped the machine in emergency.
The safety speed monitor can be reset by pressing the NC reset button.
Error 1313 Safety Monitar Fehlerfaststellung 2 (axis Y)
This is an error along the Y axis
Question:
* This error appears automatically or only in manual mode?
When do you change the tool step by step?
Check Y-axis load during tool change

[Samed42]

Hi

1313 Safety monitor error detection
The safety speed monitor detected over-speed or abnormal state and stopped the machine in emergency.
The safety speed monitor can be reset by pressing the NC reset button.
Error 1313 Safety Monitar Fehlerfaststellung 2 (axis Y)
This is an error along the Y axis
Question:
* This error appears automatically or only in manual mode?
When do you change the tool step by step?
Check Y-axis load during tool change

Hi
https://youtu.be/dUjl6TBEUzA
I showed you how the error was with the video. while this process is in manual mode