U100L - C axis Zero

[andytpks]

Hi!

Where is the parameter for setting the C zero Axis in U100L control?

I check and check but i don't look anything

In system parameter i have X, Z, M, T, but not C

And i try to change optional parameter but change only "CD" parameter so change the M19 parameter

But not the C zero axis... any solution?

Thank you so much

Similar Threads:

• Problem- Okuma LB300///OSP U100L
• Newbie- OSP -U100L
• Run from line U100L
• OSP U100L
• Newbie- What is the difference between OSP-U10L & OSP-U100L?

[OkumaWiz]

You are missing the obvious one. It is not in parameter mode it is in zero set mode. Each axis including C will have a Zero Set.

Best regards,

[deadlykitten]

hy, are you looking for program zero, or for encoder zero ?
... program zero can be edited for : xzc
... encoder zero : all_above + mts

please, describe a bit more what you wish to do

if you are looking for encoder zero, then try syspara2, but i am afraid that this menu is not on your machine, so maybe all you need is screen-extend inside the menu where you set program zero / kindly