You are missing the obvious one. It is not in parameter mode it is in zero set mode. Each axis including C will have a Zero Set.
Best regards,
Hi!
Where is the parameter for setting the C zero Axis in U100L control?
I check and check but i don't look anything
In system parameter i have X, Z, M, T, but not C
And i try to change optional parameter but change only "CD" parameter so change the M19 parameter
But not the C zero axis... any solution?
Thank you so much
Similar Threads:
You are missing the obvious one. It is not in parameter mode it is in zero set mode. Each axis including C will have a Zero Set.
Best regards,
Experience is what you get just after you needed it.
hy, are you looking for program zero, or for encoder zero ?
... program zero can be edited for : xzc
... encoder zero : all_above + mts
please, describe a bit more what you wish to do
if you are looking for encoder zero, then try syspara2, but i am afraid that this menu is not on your machine, so maybe all you need is screen-extend inside the menu where you set program zero / kindly
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...