pls, how to remove this part ? tailstock, y adjustment, attached


Results 1 to 4 of 4

Thread: pls, how to remove this part ? tailstock, y adjustment, attached

  1. #1
    Member deadlykitten's Avatar
    Join Date
    Jun 2015
    Location
    Antarctica
    Posts
    2848
    Downloads
    0
    Uploads
    0

    Default pls, how to remove this part ? tailstock, y adjustment, attached

    please, how to remove this part ? tailstock, y adjustment, attached

    i believe there is no air underneath, making it hard to pull out / kindly

    Similar Threads:
    Attached Thumbnails Attached Thumbnails pls, how to remove this part ? tailstock, y adjustment, attached-untitled-png   pls, how to remove this part ? tailstock, y adjustment, attached-img_20191019_143321-jpg  
    ... chip happens


  2. #2
    Member
    Join Date
    May 2016
    Location
    United States
    Posts
    122
    Downloads
    0
    Uploads
    0

    Default Re: pls, how to remove this part ? tailstock, y adjustment, attached

    If 20 is an O-ring, I'd say it pulls straight out. Try to work a stiff thin blade under the edge and work it out. That or maybe take a rubber nozzle tipped air gun and shoot down the center hole. Can you rotate it, even though it looks like the end piece is caught in a groove on the main shaft. Nothing but the o-ring is holding it from what I can tell. Just work it out. Wiggle-wiggle-wiggle...

    Dave



  3. #3
    Member
    Join Date
    Aug 2016
    Posts
    93
    Downloads
    0
    Uploads
    0

    Default Re: pls, how to remove this part ? tailstock, y adjustment, attached

    If the center bolt will come out, a slide hammer should work.



  4. #4
    Member deadlykitten's Avatar
    Join Date
    Jun 2015
    Location
    Antarctica
    Posts
    2848
    Downloads
    0
    Uploads
    0

    Default Re: pls, how to remove this part ? tailstock, y adjustment, attached

    Try to work a stiff thin blade under the edge and work it out.
    hy giant clearance is pretty small, <0.5mm, and whatever would fit in there, is flexibile; i thought to force it a bit by using a 'sharp' screwdriver, but this raised the part a bit, and tilted it; so i tried to use 2 screwdrivers, one on each side, using gentle force, but nothing happened

    That or maybe take a rubber nozzle tipped air gun and shoot down the center hole
    i tried also this, also i tried to tighten the screw to the max depth, believing that this will raise the part, but it did not work, because the center hole is blind

    If the center bolt will come out, a slide hammer should work.
    hy footpetaljones, i google that, and i have improvised one, by using a long M6 screw, a M8 nut, and a heavy little thing; it worked, thanks


    when i tried to put it back, even without the o-ring, it was a bit of resistance, because the air had no place to go out; maybe i will make a through hole in it, i don't know, is ok for now / kindly

    ... chip happens


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

pls, how to remove this part ? tailstock, y adjustment, attached

pls, how to remove this part ? tailstock, y adjustment, attached

pls, how to remove this part ? tailstock, y adjustment, attached