Programming tailstock advance on program osp 5000

[nikolaiownz]

Hey

I am making some parts that require tailstock so my program faces and centerdrill my part and I've manual reset and advanced the tailstock in MDI with M56 and restarted the program for now.

I would like to advance the tailstock in the program but I had no luck.

Tryed

M05
M157
M56
M03

But the peogram stalls after the tailstock advance.

Anyone can tell me how it's done ?

Ps. My advance pedal dosent work aswell only the retract

Sendt fra min EML-L29 med Tapatalk

Similar Threads:

• Solved V25: Simple Part, advance programming
• Newbie- Tailstock Advance on Hitachi Seiki Hi Tec-Turn 23SIII
• Need Help!- Programming Tailstock
• EA/ISO programming of tailstock
• tailstock advance code

[OkumaWiz]

Do you have tailstock advance confirmation?

Normally foot pedal should work unless some interlock is preventing it Do you get any alarm? Does tailstock try to advance or doesn’t even try?

If you check your I/O is the solenoid advance signal activating?

Any other machine options that may be preventing it like part catcher or touch setter?

Best regards,

[nikolaiownz]

Do you have tailstock advance confirmation?

Normally foot pedal should work unless some interlock is preventing it Do you get any alarm? Does tailstock try to advance or doesn’t even try?

If you check your I/O is the solenoid advance signal activating?

Any other machine options that may be preventing it like part catcher or touch setter?

Best regards,

I found out that the confirmation was not on so i adjusted it and not it works in auto and I can do it in the program. My advance pedal still dosent work it might be a lose connection. My retract works no problem

I got have part catcher or tool setter on this lathe.

Sendt fra min EML-L29 med Tapatalk

[nikolaiownz]

I don't have tailstock and part catcher

Sendt fra min EML-L29 med Tapatalk

[OkumaWiz]

Go into check data and look for input from foot switch. Should be next to retract input.

[nikolaiownz]

Go into check data and look for input from foot switch. Should be next to retract input.

In the parameters ?

Sendt fra min EML-L29 med Tapatalk

[nikolaiownz]

I can't find where I can see it the foot switch is working

Sendt fra min EML-L29 med Tapatalk

[OkumaWiz]

It is not in the parameters but if you go to manual mode and extend a couple of times you should see a key that says check data. Push it and the page down until you see the EC Inputs. You will find it in there.

[nikolaiownz]

It is not in the parameters but if you go to manual mode and extend a couple of times you should see a key that says check data. Push it and the page down until you see the EC Inputs. You will find it in there.

Cheers mate. Will check it today when o get in the shop

Sendt fra min EML-L29 med Tapatalk

[nikolaiownz]

It is not in the parameters but if you go to manual mode and extend a couple of times you should see a key that says check data. Push it and the page down until you see the EC Inputs. You will find it in there.

I can't seem to find anything under ec inputs.

Sendt fra min EML-L29 med Tapatalk