Reply with QuoteG33 can do continuous coordinates so multiple x-z coordinates can be used. This makes possible such things as oil ring grooves using threading style passes.
Best regards,
Thread cycle command
Hi
What is the difference between G31 and G33?
Thanks
Similar Threads:
https://www.facebook.com/okuma.tuning
Re: Thread cycle command
G33 can do continuous coordinates so multiple x-z coordinates can be used. This makes possible such things as oil ring grooves using threading style passes.
Best regards,
Experience is what you get just after you needed it.
Re: Thread cycle command
hello again, continuous mode is possible under 34; about 33 & 31, i believe that 31 was available on older osp generations, maybe capable only on longitudinal threading, while newer ones started to use 33
kurmay, do you really care about finding a difference ? kindly
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
