please, how to set igf to put M01 after each operation ?

[deadlykitten]

hello, please, how to set igf to put M01 after each operation ? kindly

Similar Threads:

• operation
• code for actual operation accordingly to next operation
• Best Cut Operation?
• operation
• 102 Mis Operation

[deadlykitten]

please mr wizard, where are those parameters ? thx

[deadlykitten]

heeei, thank you mr Wizard >:D<

https://we.tl/t-xY6eekdwQT

i just looked into the manuals that i sent to you, and there is info about the M01 inside them / very interesting :) hmm, i should have searched more careful

Enter IGF then extend until you see IGF parameters

but of coooourse, the screen extend ... i have modified next parameters / kindly :)

dimension parameter
 
    40 tool index pos x          - an integer number just a bit greater then X_positive_soft_limit
    41                z          - 250
 
integer parameter
 
    01 maxi spindle speed        - 2000 i don't like spinning the 10" chuck at higher rpms, even if the spindle can reach 4000 rpm
    82 space deletion in program - one space
    85 M01 output or not         - output
    92 thread infeed patern      - M74
    93 thread cutting mode       - M33
 
each process parameter
 
    ccs off for roughing & finishing - by default, i cut at 2000rpms, steel up to o100-130mm