Okuma LB10 Turret removal

[Markiewicz55]

I have an LB10 lathe that is leaking coolant to the other tool holders. I am guessing some seal is bad on the back side of the turret.

I tried removing it once but am missing something. Does anyone know the process to remove the turret to replace this seal?

Thanks Much!

Similar Threads:

• Need Help!- Software for Okuma LB10 with OSP5000L-G from 86
• OKUMA LB10 SERVO ALARM
• Help - LB10/15 Okuma Lathe with OSP5000L-G
• Help Okuma LB10 servo amp error
• How to output Parameters for Okuma LB10

[landslide1]

I have the parts manual for the 87 model. not really a service guide but it gives you an idea of how it goes together.
let me know if you want a scan

[Markiewicz55]

If you would have the time and could copy it down I think it would be helpful. To me and others in the future looking for this that would be a big help. Thanks much!

[landslide1]

lb10 1.pdf
lb10 2.pdf
lb10 3.pdf
lb10 4.pdf
lb10 5.pdf
lb10 6.pdf
lb10 7.pdf

- - - Updated - - -

sorry about the funny rotation on the scans

[MCR-B II]

?n number 3 , 9.part has only 1 hole. Coolant flows through this hole. If there is high pressure coolant pump ,maybe it is normal. If normal pressure pump, the gap between part number 9 and 12 is bigger than normal. I think this the problem. Not back side.