So i'm still new to the Okuma world. I'm coming from the HAAS and Fadal world.
I can't get the tool lengths to read on my Okuma. They all read correctly if I set each individual tool on every different part or setup. The way i'm used to doing it is setting up each tool off the table then using the Z work offset. My Okuma isnt doing this. I don't know if my G-Code is correct or even what the G-code is for pulling up the Z offset.
1. set each off off the table and insert into tool table
2. touch one tool off the part and insert into work Z offset.
but no matter what I do it still think that the Z zero is off the table. is there a G-Code to pull up the tool length table seperate from the Z work offset?
here is a short sample to the G-code mastercam is posting out
OKuma Tool Length Problems
Reply with Quote
