Battery Change Utility OSP-7000L

[johnpool]

I have an OSP-7000L control lathe that I need to change the batteries in and I have the battery change utility on a floppy disk, however we changed out the floppy reader with a usb reader (emulator?).
Does anyone know how I can get the Battery Change utility from the floppy onto a thumb drive?
I did try to use the OSP reader program ver. 2.2.0.1 to transfer battery change utility from floppy disk to a thumb drive but I am not having any success. Is there instructions as to how to use this program or maybe if there is an English version that I might understand? any help will be greatly appreciated!

Similar Threads:

• Need Help!- Servo problem after battery change
• 2100 NCK ALARM 810D - NEED TO CHANGE BATTERY - WHERE IS THE BATTERY LOCATED?
• Problem- CMOS Battery Low after RTC Change
• Problem- Battery change OSP7000L
• Problem- Battery change resolved into problem

[astral]

try this tool to make a image from floppy and put a image back in usb with free usb tool

[johnpool]

Thank you,
I will try this, I ended up switching it back to floppy drive just so I could get the batteries changed before I lost everything, I will give this a try and see if it comes up like it should, Thanks again!

[gibsoni]

You shouldn't have an issue changing the batteries with the machine powered up.

I had mine out the other day to check them.

Obviously play carefully around high voltages with machine powered up.

[johnpool]

ok, thank you.

[astral]

You shouldn't have an issue changing the batteries with the machine powered up.

I had mine out the other day to check them.

Obviously play carefully around high voltages with machine powered up.

you change and reset battery alarm on okuma until now?

i think ... NO

you need battery reset disk and Johnpool ask something, you answer correct to him?