hi set the M90+M91 the same way you did with the M76+M71
check this thread for ctr codes about the parts catcher : https://www.cnczone.com/forums/okuma...ing-parts.html
kindly
Hello everyone.
A simple question, is it possible to get the IGF to output M90/M91 (door close/open)?
I managed to get the code for the parts catcher (M76/M77) to be output and I hope it is possible for the door also.
Machine: Okuma LB300-MW Osp U-100L.
Thanks.
Best Regards, Samuel
Similar Threads:
- Problem- Okuma LB300///OSP U100L
- Need Help!- Okuma LB300 Parts Manual
- Need Help!- C-axis will not clamp. Okuma LB300
- Need Help!- Okuma Turn Space LB300
- Problem- Okuma OSP U100L serial on a LB300
hi set the M90+M91 the same way you did with the M76+M71
check this thread for ctr codes about the parts catcher : https://www.cnczone.com/forums/okuma...ing-parts.html
kindly
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
Hello.
I set the part catcher by a parameter. Is there one for the door too? In that case, which is it?
Thanks.
pls, how do you set the catcher by a parameter ?
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
I have searched but did not find were I set that. But there is a parameter somewhere. Sorry.