Okuma LB300 auto door

[vesene]

Hello everyone.

A simple question, is it possible to get the IGF to output M90/M91 (door close/open)?
I managed to get the code for the parts catcher (M76/M77) to be output and I hope it is possible for the door also.

Machine: Okuma LB300-MW Osp U-100L.

Thanks.

Best Regards, Samuel

Similar Threads:

• Problem- Okuma LB300///OSP U100L
• Need Help!- Okuma LB300 Parts Manual
• Need Help!- C-axis will not clamp. Okuma LB300
• Need Help!- Okuma Turn Space LB300
• Problem- Okuma OSP U100L serial on a LB300

[deadlykitten]

hi set the M90+M91 the same way you did with the M76+M71

check this thread for ctr codes about the parts catcher : https://www.cnczone.com/forums/okuma...ing-parts.html

kindly

[vesene]

Hello.

I set the part catcher by a parameter. Is there one for the door too? In that case, which is it?

Thanks.

[deadlykitten]

pls, how do you set the catcher by a parameter ?

[vesene]

I have searched but did not find were I set that. But there is a parameter somewhere. Sorry.