Adjusting Max jog speed IPM on a MX45VAE w/ OSPU100M?

[O-MX45VAE]

My MX45 seems to have a setting for a max IPM of 400, so any time feed >400, it'll automatically reduce it.

Trouble is I have a Kitagawa 5 axis table, and feed is read as DEGREES per minute. So when it has 400 feed on a 5 axis movement, it's going really slow. It is capable of 22 RPM.

Is there a way to adjust the maximum feed rate to something much higher? I am generating tool paths with feeds of 1500 some times (which is only 4 rpm) on a 5 axis movement. I can limit my XYZ feeds in my cad software, but when it comes to all 5 I need that feed higher.

Similar Threads:

• Spindle Speed and Adjusting the Baldor Drive
• Adjusting Speed/Feed/SFM with good chip...
• Need Help!- Okuma MX45VAE Oil Chiller
• MX45VAE active tool pot orientation
• Adjusting Spindle Speed on Series I

[deadlykitten]

Hi, so far i never heard of a feed limit; it may be a setting that came with the rota table. Did you tried asking your rep ?



rpm depends how close/far you cut from center

C axis on lathe + HiCut uses 360*=360mm, and allows both G94&95; i don't know, maybe it helps to shift from 94 to 95? kindly

[O-MX45VAE]

No ITF, so G94/G95 don't work.

The setting is in the U100M, not the table. Machine is 15 years old and purchased second hand, so no rep available.

[O-MX45VAE]

Bump...still having trouble finding this feed rate setting

[deadlykitten]

go over morris midwest, gosiger, okuma's tech centers ... call them maybe you hit into the right person ... good luck

[O-MX45VAE]

Bit 15.7 set to 1 changed feed 1 = 25.4 degrees for rotary axis

Thanks to Gosiger Support for the help