OSP P300S - Locating part with a turning tool

[Sammyen]

Hi
Im trying to figure out how to execute an idea I have.Sometimes the material length varies with a few MM and I have to run either some air cuts on a few, or large first cuts on a few. I'd like to do this a better way.

My idea: Start at X200 Z10 and run a sub-program.
In this sub-program the machine will move Z- while monitoring spindle load.(Either continuous monitoring or move 0,5mm, measure load, move 0,5mm and measure until it reaches a number I choose.)
When the machine hits, lets say, 15% load I would like to transfer its current location in Z to V1 and return to a safe spot.

To do this I need two things.
1. A way to check current spindle load.
2. A way to transfer current location in an axis to a parameter. *****=V1

Similar Threads:

• Need Help!- MAZAK ST35 tool locating Pin Replacement
• Okuma OSP-P300S LACK-TL
• Turning - One Tool for drill and inside turning?
• Need Help!- Locating a part
• Locating a part on a milling plate

[deadlykitten]

hy sammyen / check post 4 in here : https://www.cnczone.com/forums/okuma...gin-lathe.html

that thread is about this topic / kindly

[Sammyen]

Thanks again. Will read. Most likely I got questions but I will post it in your thread