Reply with Quotehow to do the eccentric program.20mm rod 5mm offset 10mm length
Okuma MC3VA Z axis ballscrew
My Okuma MC3VA VMC with OSP500M-G operating system is experiencing clunky operation and often becomes stuck in the Z axis operation resulting in a "Dif Over" alarm. I'm looking for advice or instructions on adjusting or replacing the Z axis ballscrew assembly. Since I have been unable to obtain the proper manual, if anyone has instructions on this procedure that they could share with me it would be greatly appreciated. Many thanks!
Similar Threads:
Re: Okuma MC3VA Z axis ballscrew
how to do the eccentric program.20mm rod 5mm offset 10mm length
Re: Okuma MC3VA Z axis ballscrew
hi; mill it; use G102/G103 ...Originally Posted by muthumaanick
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
