hello there is a gang lathe in the house, from citizen ; it was a bit bumpy during repositioning
check this :
i hope someday Okuma will allow acces, from code, to such parameters / kindly !Code:M350 X15000 Y15000 Z15000 override maximal rapids : enabled M360 X3 Y3 Z3 override rapid acc/decc : enabled; acceleration and decceleration is 3x slower than default // some linear movement M361 override rapid acc/decc : disabled; defaults restored M351 override maximal rapids : disabled; defaults restored *M351 and M350 X35000 Y35000 Z35000 are equivalent *M361 and M360 X1 Y1 Z1 are equivalent