Re: NC Spec Code Page
hello guys, one question please :
there are these 2 lathes : lb3oooex2 osp300 :
... MCW from 2012, windows xp
... MCWY from 2014, windows 7 or 8 ?
if i would buy for the 1st one "load monitor 2", will i be able to install it also on the 2nd ? kindly !
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
Re: NC Spec Code Page
No, machine software is serial number specific, so you will need to order the option on each machine.
If you have other options such as cycle time reduction, spindle orientation, etc, order them at the same time to reduce the cost by getting them all at once under the same software package "creation".
Experience is what you get just after you needed it.
Re: NC Spec Code Page
thx mr Wizardthere is basic ctr, M18/M19, C axis ... i think to get lm2 and some tailstock ctr codes
please, do you think that i should think of some other accesorie ? kindly
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
Re: NC Spec Code Page
Where is the serial number of the machine being stored? (eprom,disk etc)
Are there any way to change machine serial number?
https://www.facebook.com/okuma.tuning
Re: NC Spec Code Page
hyOriginally Posted by kurmay
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...
Re: NC Spec Code Page
hi friend
iam try to change the spec code file , but when power on again , it show 955 ALARM-P Spec code : data file 15xxxxxx.
do you why ?
it's OSP-P200 system , please help me .
Re: NC Spec Code Page
hi friend
i have change the spec code file , and power on , but it have alarm : 955 ALARM-P spec code : data file 1515xxxx
can you help me ? it's OSP-P200 system .
Re: NC Spec Code Page
Why is this showing up? Nothing posted here since 2016?
Experience is what you get just after you needed it.
Re: NC Spec Code Page
Test Post
Jim Dawson
Sandy, Oregon, USA
Re: NC Spec Code Page
Ping
https://www.facebook.com/okuma.tuning
I can offer a lot Okuma NC Specification Code and osp software?My email address?
l_shuguang@sina.com?Please contact me
Re: NC Spec Code Page
I can offer a lot NC Specification Code and osp software
I can provide a lot of technical support
Email l_shuguang@sina.com
Better if you can use WeChat
My WeChat ID xin_men
Reply with Quote
