Maybe cleaning of control modules could help. Clean the rack connectors also.
Hello all
i have this led on cpu rack on and the screen is like foto bellow when starting machine
machine is Okuma MC 4VA OSP5000-G
and the screen is
this was
happened during work some parts in auto mode
Before this event I had other interruptions solved with a power of
such as would be the picture below
and
thanks in advance
can someone help me with some tips on where to fix the problem ?
Similar Threads:
Maybe cleaning of control modules could help. Clean the rack connectors also.
I already cleaned the connectors on the boards of the rack and still does not start
battery is 3.7v is ok
Check power supply stability or try other ±24V PSU. Try re-installation of Okuma software.
I changed the CPU board (200US) it helped me.
The lathe worked more then half year.
hello
i have the same problem could you help me
Change the board. But if you can no do it change CNC to China. It will be more cheaper then buy board.
I remove all OKUMA CNC with servo motors and drivers and install new China CNC TD1000 with 2 new servo motor and 2 new servo drive.
I have no any problem now.
hy aike this is the 2nd time i hear about someone replacing the cnc
here is the other : https://www.cnczone.com/forums/okuma...ml#post2076724
i think is a god idea ( especially if you can do it yourself ), to bring back to life an older model; thus if machine/mechanical is ok, then why not just rewire it ? kindly
we are merely at the start of " Internet of Things / Industrial Revolution 4.0 " era : a mix of AI, plastics, human estrangement, powerful non-state actors ...